Angelo Po FX101 E 2, Installation And Operation Manual

Page: 41 / 124

Combination Oven Installation and Operation Manual
41
Section 8
Troubleshooting
TROUBLES + OOTING
The appliance has been tested before being put into
service.
The information provided below is intended to assist
LQWKHLGHQWL¿FDWLRQDQGFRUUHFWLRQRIDQ\LUUHJXODULWLHV
and malfunctions which might occur during use.
Fault Cause Remedy
The appliance does not
switch on Fuse "blown"
5HSODFHWKHIXVHVHHSDJH
(OHFWURQLFFLUFXLWERDUGGDPDJHG
Contact an authorized service agent
Cooking cycle does not
start or stops suddenly Control board electronic circuit board
damaged Contact an authorized service agent
$ODUPWULJJHUHG &RQVXOWWKH.H\WR$ODUPVWDEOH
Safety or protection device (safety
WKHUPRVWDWRURYHUORDGFXWRXWWULSSHG
&RQVXOWWKH.H\WR$ODUPVWDEOH
Press device reset button
The user can solve some of these problems on their
RZQEXWLQPRVWFDVHVVSHFL¿FWHFKQLFDONQRZOHGJH
or skill is required. More advanced troubleshooting
may need to be done by an authorized service agent.
ALARM IDENTIFICATION
If the problem or fault noticed is not among those
OLVWHG LQ WKH WDEOH FRQVXOW WKH “Key to Alarms”
table.
The information provided is intended to identify the
DODUPVLJQDOVZKLFKDSSHDURQGLVSOD\
IMPORTANT _________________________
Press E utton 12) to reset the alar P and
the cooking cycle restarts auto P atically
if this is not the case press start key 16).
7
12
16