62
ANGELCARE
®
MONITOR INSTALLATION
Please refer to SETTING pages for further details
Mattress
1.
Remove mattress from the crib. Place
a hard board in the center base of the
crib, right under the Sensor Pad(s).
���
���
Sensor Pad
HardbBoard
(not included)
I sensor pad
2 sensor pads
(Available in certain countries only)
2.
Position the Sensor Pad (as shown),
in the center of the crib
. Make sure
the printed side faces up. Do not
place any bedding between the
mattress and the Sensor Pad.
Crib center
Crib center
1
. Remove the belt clip, unscrew the
back panel and insert the 3 AAA
NIMH rechargeable batteries
included into Parents Unit.
2
. Connect the AC adapter to the
Parents Unit charger and plug
adapter into the electrical outlet.
Charge for a minimum of 10
continuous hours before using the
monitor for the first time.
���
3. Turn the Parents Unit ON by pushing
and holding the POWER button for 2
seconds.
4.
Screen
A
will appear and then turn to
the video caption
B
. When the
Nursery Unit is OFF, screen
C
will
appear and the Parents Unit will
automatically shut off after 1 minute.
In this case, turn ON the Nursery Unit
and then turn ON the Parents Unit
again.
���
POWER
On/Off
���
A. INSTALL THE PARENTS UNIT
���
A B C
Crib Base
B. INSTALL SENSOR PAD UNDER THE MATTRESS
E
N
AC1100 BELGIUM 13.07.2012 13-05-02 5:07 PM Page 62
