8-Pin DMD Power Cable
(Remove entire cable
from the game)
14-Pin DMD Ribbon Cable
(Unplug cable from DMD
and leave other end
connected to game)
Figure A
Cable connected to lamp
board mounted to speaker
panel. Lamp boards are not
present on most games.
Ground Lug
Carefully remove the translite from the backbox and then lower
the speaker panel to the position shown in Fig. A to gain access
to the backbox.
Installation Instructions
for
WPC
-
CHROMA eDP
Be sure to turn
OFF
the power to the pinball machine before
installing the ColorDMD display.
Tools Required
:
Remove and save all of the DMD mounting hardware. Remove
the original DMD from the game and store it in a safe place.
1
2
3
STEP
STEP
STEP
!
Disconnect the DMD power and ribbon cables from the DMD.
Unplug the DMD power cable from the high-voltage A/V board
J-604 (see Fig. E), and
remove this cable from the backbox
.
Congratulations on the purchase of a new ColorDMD display. The ColorDMD
will enhance your pinball machine by introducing
color
to the dot matrix
display graphics produced by the game.
If pinball machine has a lamp board mounted to the speaker panel
(see Fig. A), it can remain in place. Use alternate ColorDMD
mounting holes shown in Fig. C. Ensure lamp board PCB does not
contact ColorDMD metal bracket.
Phillips Screwdriver
5/16" nut driver
1/4" nut driver (if game has a lamp board
mounted to the speaker panel)
STEP
4
•
•
•
ALL RIGHTS RESERVED - US PATENT 8,773,452 B2 - COPYRIGHT 2016 - COLORDMD DISPLAYS LLC
