Plug Into
Power Driver
Board
J-116
Optional
:
Only use the male-to-male
adapter to re-connect a
pre-existing cable back
into J-116
Plug Into
ColorDMD
PWR
J-603
Figure E
J-116
J-604
Route the new ColorDMD
Power Cable along with
the existing game cables
for a clean install.
DMD Controller
Board
ColorDMD Ground Cable
securely installed.
Grounding lug sandwiched between
metal bracket and 5/8" black spacer.
Power Driver
Board
Locate the included 4-pin ColorDMD power cable. One end of the
cable has a single connector (see Fig. D). Plug this connector
into the PWR header (see Fig. C) on the ColorDMD.
Plug the other end of the new ColorDMD Power Cable (see Fig. D)
into J-116 on the WPC Power Driver Board (see Fig. E). If an
existing cable is currently plugged into J-116, disconnect it before
connecting the ColorDMD power cable
.
If you disconnected a cable from J-116 in the previous step, use
the included male-to-male adapter to re-connect this cable to
the available center connector on the ColorDMD power cable
(see Fig. D). Otherwise, do not connect the male-to-male
adapter and store it in a safe place.
9
10
Figure D
11
STEP
STEP
STEP
TIP
ALL RIGHTS RESERVED - US PATENT 8,773,452 B2 - COPYRIGHT 2016 - COLORDMD DISPLAYS LLC
