Anderson Group
Self-loading Trailer – Operator's Manual
55
NOTE:
When the bale counter on the trailer indicates that loading
is complete, automatic loading cannot be activated. The
screen will display "Trailer full".
To adjust the counters, see section 5.6
2. If needed, adjust the grabber position to the orientation of the bale to be loaded by pressing
.
NOTE:
If needed, adjust the angle of the loading arm and the
grabber pressure to get a better grip on the bales (see
"Adjusting the loading arm angle and grabbing pressure"
on page 63).
3. Position the grabber so that its arms are on either side of the bale and slowly move forward.
When the grabber sensors detect the bale, the loading sequence starts automatically. See
Figure 22 for the loading sequence.
NOTE:
Make sure that the bale is in the centre of the grabber
when you pick it up, especially if it is vertical; if it is not, it
could topple over and you could drop it.
4. Repeat steps 2 and 3 for each bale to be loaded until the trailer is full or the maximum
number of bales has been reached. Once loading is complete, the loading arm automatically
returns to transport position and the transport mode screen appears.
NOTE:
To stop loading before the trailer is completely full, press
. The loading arm will automatically be raised 10
degrees.
To resume loading, press
again. The automatic
loading process will resume where it left off.