Anderson Group
Self-loading Trailer – Operator's Manual
63
5.5 Adjusting the loading arm angle and grabbing pressure
The loading arm angle can be adjusted to get a better grip on bales when the terrain is not perfectly
flat.
The grabber pressure can be adjusted to the density of the bales to grasp them better.
NOTE:
The loading arm angle and grabber pressure are factory
programmed. These values can be adjusted to the bales
and terrain.
1. In the settings menu or on the loading screen, press
. One of the following screens will
appear, depending on the bale position that was selected:
Figure 29 — Loading Arm Angle and Grabber Pressure Adjustment Screen
2. Press
or
under value 1 to adjust the loading arm angle in relation to the trailer. The
angle is in degrees.
3. Press
or
under value 2 to adjust the pressure exerted by the grabber on the bale.
The pressure is in psi or bar.
4. To adjust the angle and grabbing pressure for bales in the other position, press
and
repeat steps 2 and 3.
5. Press
to return to the settings menu.
5.6 Adjusting the counters and exporting the data
5.6.1 Correcting the bale counter
To correct the number shown in the bale counter on the trailer:
