Anderson IFX720, Operator'S Manual

Page: 45 / 133

Anderson Group Round Bale Wrapper IFX720 – Operator's Guide 45
Connecting the remote control and receiver
The remote control and receiver are connected at the
factory. If you lose or break the remote control, you will
have to replace it and then have to connect it to the
receiver. You must connect the remote to the receiver. To
connect the remote to the receiver:
1. Remove the key from the ignition.
If you leave the key in the ignition,
the
engine could be started
accidentally. This could result in
serious injury or even death.
2. Turn on the receiver by pushing the blue button on
the wrapper control panel (Figure 58).
3. Press and hold the start engine button on the
remote control (button 7)
4. Push the receiver's Address Learn button (Figure
60 ). The Address Learn LED will blink green to
indicate that the receiver has found a signal and
the remote is now connected.
5. Release the buttons.
Starting the wrapper
To start the wrapper with the remote control:
1. Push the blue button on the control panel of the
wrapper (Remote steering) to turn on the receiver.
The blue button lights up when remote steering is
activated.
NOTE: When remote steering is activated, the
engine can
only be started with the
remote control.
The engine will automatically turn off
when remote steering is activated.
2. Turn the engine key to ON .
3. Be sure that the emergency stop button is pulled
out and the safety guard is closed.
4. Press the green button on the remote to start the
engine.
NOTE: If the engine was stopped without the
remote control, you will have to press the
stop engine button on the remote control
before you will be able to restart the
engine with the remote control.
If the engine does not start, press the stop
engine button on the remote control and
then try to start the engine again.
Always turn off the receiver (the blue
button on the wrapper control panel)
after using it to avoid draining the
wrapper battery.
Steering the wrapper
To steer the wrapper with the remote control, press the
left or right button depending on which way you want to
move the wrapper.
NOTE: The wheels of the wrapper move by
pulses. This prevents the wheels from
turning all the way when a button is
pressed.