Anderson IFX720, Operator'S Manual

Page: 39 / 133

39 Operator's Guide – Round Bale Wrapper IFX720 Anderson Group
Problem Possible cause Solution
The pusher comes back before
completing its cycle. The pusher is not reaching
the stopper because the
spring on the automatic
system is too tight. Adjust the spring so that its bracket is at
approximately a 45° angle from the table. See
section — Adjusting the Spring on the Automatic
System on page 35.
The pusher is moving forward
at a normal speed, but the
hoop is turning slowly. The wrapping speed control
is set too low. Increase the wrapping speed.
The hoop activation lever is
not activating the automatic
system. Adjust the hoop activation lever. See section
Adjusting the hoop activation lever on page 31.
The pusher is not coming back
at the end of its pushing cycle. The automatic system is
dirty or contains debris that
is preventing it from working
properly. Clean the automatic system.
The spring on the automatic
system is not tight enough. Adjust the spring on the automatic system. See
section — Adjusting the Spring on the Automatic
System on page 35.
The pusher has come all the
way back, but the engine is still
straining as if it did not
complete the cycle. The trigger travel limit has
not been adjusted properly. Adjust the trigger travel limit. See section
Adjusting the travel limit on page 33.
Table 11 — Troubleshooting the Hoop
Problem Possible cause Solution
The hoop is not turning at
all or is not turning fast
enough. The hoop speed control has
not been adjusted properly. Increase the speed (between 2 and 10).
The drive wheel is slipping
on the hoop. 1. Tighten the hoop wheel spring. See section
Adjusting the hoop drive wheel on page 35.
2. Check the tire pressure and adjust it if needed.
See section 1.3 for the required pressure
levels.
3. Change the tire if it shows excessive wear.
The drive wheel is not
turning. 1. Check the hydraulic oil level and check for
leaks and damage. Repair if necessary. Add
AW 32 hydraulic oil to the tank.
2. Have hydraulic systems specialists check the
condition of the wheel engine and replace it if
needed.
The hoop activation lever is
not activating the automatic
system. Adjust the hoop activation lever. See section
Adjusting the hoop activation lever on page 31.