Anderson IFX720, Operator'S Manual

Page: 32 / 133

Anderson Group Round Bale Wrapper IFX720 – Operator's Guide 32
Before proceeding, disengage the
hoop by placing the manual hoop
control lever in rear position (manual
mode).
The hoop is disengaged if the pointer
is at a 90° angle to its support plate.
Adjusting the activation lever
without disengaging the hoop will
damage the wrapper.
To adjust the hoop activation lever:
1. Put the pusher travel stopper in the seventh
position from the rear of the wrapper (Figure 40).
Figure 40 — Adjusting the Hoop Activation
(Pusher Return Stopper)
2. On the control panel, set the hoop speed control
to 0 and push the hydraulic stop button
(Figure 2).
3. Position the pointer and hoop activation lever as
shown in Advanced adjustments:
l
Push the pointer all the way to the front of the
machine. It should form a 45° angle (Figure 41).
Figure 41 — Adjusting the Hoop Activation Lever
(Position of the Activation Lever)
l
Start the engine.
l
Push the pusher's manual start (Figure 42).
Figure 42 — Adjusting the Control for the Hoop
(Manual Start of the Pusher)