Edition 3
Rev G
Section 4
4-93
Press the
to change, then
to
desired number, then press the
.
CHART MESSAGE NUMBER
1
Selections
1 to 12
CMxx COPY / INITIALIZE
NO
Selections
NO YES
Press the
to change, then
to
desired choice, then press the
.
7. Press the
and the display advances to the next operator message to be programmed. Refer to the
beginning of this section, page 4-85.
4.1.16 CHART MESSAGES
Chart Messages allow user defined text to be recorded on the chart.
From the Normal Display, press the
until CONFIGURATION is seen in the upper display line. If PASS-
WORD appears in the lower display line, the correct "password" will need to be entered before access to Configu-
ration is allowed. If CONFIGURAITON is not displayed, then Configuration has been disabled. Refer to Section
9, Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the , then the
u n t i l
CHART MESSAGES appears
in the lower display line.
1. Press the
to display CHART MESSAGES.
2. Press the
to advance to the next parameter, COPY/INITIALIZE.
O
P
E
R
A
T
O
R
&
C
H
A
R
T
M
E
S
S
A
G
E
S
Summary of Contents for AV-9000
