SFLR ALARM1 SETPOINT
X units
ñ
NOTE: Units, as programmed, will be displayed
ÿü
to change,
õö
to choose,
ÿþ
to save
Definition: This parameter allows the user to set the SFLR ALARM 1
Setpoint Value. This is the legal “Loss of Signal” setpoint
value.
ÿø
TO ADVANCE TO NEXT SELECTION
SFLR ALARM2 TYPE
[ NONE/OFF ]
[LOW SIGNAL/VALUE ]
[HIGH RATE/VALUE ]
ÿü
to change,
õö
to choose,
ÿþ
to save
Definition: MUST remain at “LOW SIGNAL/VALUE” selection for
proper utilization as “High Flow” alarm. Causes Alarm 2 relay
to be failsafe active when above “High Flow” setpoint. Above
High Flow setpoint condition will cause relay to open, sending
fault signal to Legal Flow Controller. Will result in system
divert to balance tank.
ÿø
TO ADVANCE TO NEXT SELECTION
SFLR ALARM2 SETPOINT
X
units
ñ
NOTE: Units, as programmed, will be displayed
ÿü
to change,
õö
to choose,
ÿþ
to save
Definition: This parameter allows the user to set the SFLR ALARM 2
Setpoint Value.
Revision 3.0
Section 5
32
