HWC SP DISPLAY OPT
[ NOT DISPLAYED ]
[ IN CONTINUOUS MODE ]
[ IN SEQUENTIAL MODE ]
[ IN BOTH MODES ]
ÿü
to change,
õö
to choose,
ÿþ
to save
Definition: This parameter, if active, allows the current Setpoint of the PID
controller associated with the Hot Water to be displayed.
ÿø
TO ADVANCE TO NEXT SELECTION
HWC ALARM1 TYPE
[ NONE/OFF ]
[LOW SIGNAL/VALUE ]
[HIGH RATE/VALUE ]
ÿü
to change,
õö
to choose,
ÿþ
to save
Definition: This parameter allows the user to select an optional alarm for
the Hot Water Loop. This alarm may be tied to an event flag,
LED, or relay.
ÿø
TO ADVANCE TO NEXT SELECTION
HWC ALARM1 SETPOINT
X
O
F
ñ
NOTE: Will display in
O
C if unit set for Celcius
ÿü
to change,
õö
to choose,
ÿþ
to save
Definition: This parameter allows the user to set the HWC ALARM 1
Setpoint Value.
ÿø
TO ADVANCE TO NEXT SELECTION
Revision 3.0
Section 5
22
