Page 3-1
CHAPTER 3: CONFIGURATION
3.1 CONFIGURATION
OVERVIEW
The UO-200 contains two main setup menus: The Setup (“F”) menu, which configures the UO-200
to your weigh platform and the User (“A”) menu, which enables some user options. The Setup and
User menus consist of several menu selections, each with its own sub-menu of choices.
To set up the UO-200, you must first enter the appropriate menu mode. Once there, four of the front panel keys
become directional navigators to move around in the menus, and one key is used to save or SET the
selections.
3.2 SETUP (“F”) MENU
3.2.1 ENTERING THE SETUP MENU
1. Power off the UO-200 by pressing and holding the ZERO/OFF key for about six
seconds.
2. On the rear panel move the Setup/Calibration Switch to the opposite position. See
Chapter 2 for location of the Setup/Calibration Switch.
3. Power on the UO-200. The indicator shows ” F 1” to indicate that you are in Setup
Menu mode.
3.2.3 NAVIGATING IN THE SETUP MENU
Use the directional keys shown in Figure 3-1 to move around in the Setup Menu Chart
shown in Figure 3-2 on the following page.
1.
To move to a new “F” heading, use the TARE (left) or ON/PRINT (right) key to move
right or left in the Setup Menu Chart.
2.
To move to the selection level, press the ZERO/OFF (down) key once. The current
saved selection is shown.
3.
To view the available selections for the current “F” heading, use the TARE (left) or
ON/PRINT (right) key to move through the selection field.
4.
To save a new selection, press the NET/GROSS (Set) key .To exit without saving,
press the UNITS (up) key to return to the current “F” heading.
5.
Repeat Steps 1 through 4 until the Setup Menu is programmed.
Visit www.balances.com Your Authorized A&D Dealer
