Analytik Jena 845-00003-03, User Manual

Page: 68 / 77

56 2015
Maintenance & Care
9.3 Maintenance/Inspection Instructions
9.3.1 Clean System
Proceed as follows:
1. For safety reasons, you should discard the tips.
2. Turn system power off at the main power switch, then disconnect the power
plug from the socket
3. Remove all microplates, reservoirs or wash troughs.
4. Use a mild detergent or disinfectant to clean the inner space.
5. Replace any accessory items.
6. You can turn power supply on. The system performs an initialization routine and
restores readiness for operation.

The system undergoes re-initialization and becomes operational again.
NOTICE
Never use

cleaning powder,

paint thinner or

solvents like ethanol, gasoline, acetone or isopropanol
to clean the pipettor.
Substances of this type will attack the surface of enclosure panels
(for more details refer to:

“Chemical Resistance” on page 18 ).
Use a soft piece of cloth slightly moistened with mild soap or disinfectant solution to
clean system enclosure parts.
Optionally, commercially available disinfectant wipes may also be used for cleaning.
Spraying disinfectants or similar agents onto a system surface is classified as
dangerous action and is therefore prohibited. Spray contains gases that can ignite.
NOTE
Remove contamination or damage at once.