Evaluation Board User Guide
UG-061
Rev. 0 | Page 15 of
IAR KICKSTART TOOLS
INSTALLING THE IAR KICKSTART TOOLS
The IAR Embedded Workbench KickStart version that is
provided in the evaluation kit offers an unlimited assembly
language development environment and a 4 kB compiled output
limited C environment. This environment allows the user to
write, compile, and debug code. Code can be downloaded to the
ADE71xx/ADE75xx/ADE51xx/ADE55xx and then debugged in
circuit. The USB-to-UART allows the user to set breakpoints to
debug their code. Another board, the ADE8052Z-EMUL1, can
be purchased separately which allows the user to emulate code
by stepping through code line by line.
To install the IAR KickStart tools, follow these steps:
1.
Open the
EW8051-7.30B-KS-ADI.zip
file that is located in
the IAR folder of the evaluation kit CD.
2.
Run the
Start.exe
. application file located in this folder.
This extracts the KickStart tools.
The window shown in Figure 18 appears.
08600-
020
Figure 18. IAR KickStart
3.
Click the
Software Installations
option.
4.
Click the
KickStart Edition
option shown in Figure 19.
08600-
021
Figure 19. IAR Software Installation
5.
A series of windows appears with installation options.
Select the
Install the IAR Embedded Workbench
KickStart Edition
option in each window.
6.
Click
Next
and then
Accept
on the agreement window.
7.
Then enter the license number and license key. These can
be found on the CD cover of the evaluation kit. Carefully
enter these on the respective windows and click
Next
.
8.
Prior to installing, select the location that the KickStart
tools are to be placed. If a location other than the default
destination folder is required, use the
Browse
button to
navigate to the desired location.
9.
Click
Next
on the subsequent windows to confirm the
settings and begin the installation. Note that the
installation takes a few minutes to complete.
When the installation has been completed properly, the
window shown in Figure 20 appears.
08600-
022
Figure 20. IAR Setup Complete
10.
Click
Finish
to exit the setup.
11.
To open the IAR Embedded Workbench, click the
Start
button located at the bottom left-hand corner of the
desktop, select
Programs
, then
IAR Systems
, and then
IAR Embedded Workbench
.