UG-683
EVAL-AD7403FMCZ User Guide
Rev. 0 | Page 6 of 20
EVALUATION BOARD SETUP PROCEDURES
The
EVAL-AD7403FMCZ
connects to the
EVAL-SDP-CH1Z
system demonstration platform. The
EVAL-SDP-CH1Z
board is
the controller board, which is the communication link between
the PC and the main evaluation board. Figure 2 shows a
photograph of the connections between the
EVAL-AD7403FMCZ
daughter board and the
EVAL-SDP-CH1Z
board.
After following the instructions in the Software Installation
Procedures section, set up the evaluation and SDP-H1 boards as
detailed in this section.
Warning
The evaluation software and drivers must be installed before con-
necting the evaluation board and
EVAL-SDP-CH1Z
board to
the USB port of the PC to ensure that the evaluation system is
correctly recognized when it is connected to the PC.
Connecting the Evaluation and SDP Boards to a PC
1.
Ensure that all configuration links are in the appropriate
positions (see Table 2).
2.
Connect the
EVAL-AD7403FMCZ
board securely to the J4
FMC connector on the
EVAL-SDP-CH1Z
board.
3.
The
EVAL-SDP-CH1Z
board requires an external power
supply adapter, which is included in the
EVAL-SDP-CH1Z
kit.
Connect this power supply to the dc barrel connector labeled
+12V_VIN on the
EVAL-SDP-CH1Z
board.
4.
Connect the
EVAL-SDP-CH1Z
board to the PC via the
USB cable enclosed in the
EVAL-SDP-CH1Z
kit.
Verifying the Board Connection
1.
Allow the
Found New Hardware Wizard
to run after the
EVAL-SDP-CH1Z
board is plugged into your PC. (If you
are using Windows XP, you may need to search for the
EVAL-SDP-CH1Z
drivers. Choose to automatically search
for the drivers for the
EVAL-SDP-CH1Z
board if prompted
by the operating system.)
2.
Check that the board is connected to the PC correctly
using the
Device Manager
of the PC.
a.
Access the
Device Manager
as follows:
i.
Right-click
My Computer
and then click
Manage
.
ii.
A dialog box appears asking for permission to
allow the program to make changes to your
computer. Click
Yes
.
iii.
The
Computer Management
box appears. From
the list of
System Tools
, click
Device Manager
.
b.
Under
ADI Development Tools
,
Analog Devices
SDP-H1
should appear (see Figure 12), indicating that
the
EVAL-SDP-CH1Z
driver software is installed and
that the board is connected to the PC correctly.
Figure 12. Device Manager:
Checking that the Board Is Connected to the PC Correctly
Disconnecting the
EVAL-AD7403FMCZ
Board
Caution
Always remove power from the
EVAL-SDP-CH1Z
or click the
reset tact switch (located alongside the mini-USB port) before
removing the
EVAL-AD7403FMCZ
daughter board.
12239-
0
1
1
