EVAL-AD7403FMCZ User Guide
UG-683
Rev. 0 | Page 3 of 20
GETTING STARTED
QUICK START STEPS
Follow these steps to quickly evaluate the
AD7403
ADC:
1. Install the evaluation software from the
AD7403
product
page or from the CD included in the
EVAL-AD7403FMCZ
evaluation board kit. Ensure that the
EVAL-SDP-CH1Z
board is disconnected from the USB port of the PC while
installing the software. (The PC may need to be restarted
after the installation)
2. Ensure that the various link options are configured as
outlined in Table 2.
3. Connect the
EVAL-SDP-CH1Z
board to the evaluation
board as shown in Figure 2.
4. Connect the
EVAL-SDP-CH1Z
board to the PC via the
USB cable. For Windows® XP, you may need to search for
the
EVAL-SDP-CH1Z
drivers. Choose to automatically
search for the drivers for the
EVAL-SDP-CH1Z
board if
prompted by the operating system.
5. Power up the
EVAL-SDP-CH1Z
by inserting the 12 V dc
barrel jack (included with the
EVAL-SDP-CH1Z
) into the
barrel connector l12V_VIN on the
EVAL-SDP-CH1Z
.
6. Launch the evaluation
software from the
Analog Devices
subfolder in the
Programs
menu.
7. Connect an input signal via the VIN+, J1 connector.
Figure 2.
EVAL-AD7403FMCZ
Evaluation Board (Left) Connected to the
EVAL-SDP-CH1Z
Board (Right)
12239-
002