Analog Devices EVAL-AD7403FMCZ, User Manual

Page: 11 / 20

EVAL-AD7403FMCZ User Guide UG-683
Rev. 0 | Page 11 of 20
HOW TO USE THE SOFTWARE
STARTING THE SOFTWARE
After the EVAL-AD7403FMCZ and EVAL-SDP-CH1Z boards
are correctly connected to your PC, the evaluation software can
be started.
1.
From the Start menu, select Programs > Analog Devices
> AD7403 . The main window of the software then opens
(see Figure 15).
2. If the EVAL-AD7403FMCZ evaluation board is not
connected to the USB port via the EVAL-SDP-CH1Z when
the software is launched, a connectivity error displays (see
Figure 14). Connect the evaluation system to the USB port
of the PC and wait a few seconds, and then click
Rescan and
follow the instructions.
Figure 14. Connectivity Error Alert
SETTING UP THE SYSTEM FOR DATA CAPTURE
After completing the steps in the Software Installation Procedures
and Evaluation Board Setup Procedures sections, set up the system
for data capture as follows:
1.
Select the appropriate FPGA Settings .
2. Click Single Capture or Continuous Capture .
12239-
012