ADSP-SC589 EZ-Board® Evaluation System Manual
40
LED Reference Designator
Status
LED8
1000M link
3.5.5 Power LED (LED9)
When LED9 is ON (green), power is properly supplied to the board.
3.5.6 GPIO LEDs (LED10–12)
Three LEDs are connected to the general-purpose I/O pins of the processor. The LEDs are active high
and are ON (amber) by writing a 1 to the correct processor signal.
LED Reference Designator
Processor Programmable Flag Pin
LED10
PE_13
LED11
PE_14
LED12
PE_15
3.5.7 Reset LED (LED13)
When LED13 is ON (red), master reset is active. The reset LED is controlled by the Analog Devices
ADM6315 supervisory reset circuit. A master reset is asserted by pressing SW2 which activates
LED13. For more information, see Reset Push Button (SW2).
3.6 Connectors
This section describes connector functionality and provides information about mating connectors.
