ViewStat Installation and Wiring
10
ViewStat Communicating Thermostat
Attaching the MiniVerter to the ViewStat
Before attaching the MiniVerter to the rear of the ViewStat, connect the wiring, as described below:
1.
Detach the faceplate from the base of the ViewStat.
2.
Pull the stripped/tinned wires through the cutout in the center of the base (FIG. 5).
Before mounting the ViewStat, you must attach the MiniVerter to the rear panel of the ViewStat, as
described below:
1.
Detach the faceplate from the base of the ViewStat.
2.
Pull the stripped/tinned wires through the cutout in the center of the base (FIG. 5)
3.
Connect the communications wiring:
a.
Blue
to
B-
b.
Orange
to
B+
c.
Red/White
to
A-
d.
Black/White
to
A+
4.
Connect the power wiring:
a.
Black
to
C
b.
Red
to
R
5.
Install a jumper from
RH
to
RC
.
6.
Insert the MiniVerter (connector-side first) into the guide-slots located on the bottom of the
MiniVerter mounting bracket (FIG. 6).
FIG. 5
ViewStat base with Communication, Power and Equipment terminals
Common (black)
from 24 VAC
HVAC System
Power (red)
from 24 VAC
HVAC System
jumper
from RC
to RH
from Miniverter
Communication
Terminal
cutout
Equipment
terminal
Power
Terminal
Summary of Contents for ViewStat
