![background image](http://html1.mh-extra.com/html/amx/rms-3-0/rms-3-0_manual_2938987043.webp)
Custom Device Monitoring Programming
35
RMS NetLinx Programmer’s Guide
RMSProjectorMod
This module monitors projectors. For each projector, this module will register
and monitor online/offline status, communication status, control failure, power,
and lamp hours. Communication status is registered only if the device is a two-
way device. This includes serial devices and IP sockets. Control failure is
registered only if enabled via a SEND_COMMAND, and is based on the ability
to control power. If the device is an IP-based device, the IP address NetLinx is
communicating with is also registered with RMS. Lamp hours are determined by
counting the time that the device's power is On. However, this module can also
accept the value of lamp hours as a SEND_COMMAND when you have a
projector that can provide lamp hours. Since this module registers lamp hours, it
is recommended only for use with devices that have lamps that need to be
replaced.
The following diagram is a visual description of the architecture of the
RMSProjectorMod module:
FIG. 4
Architecture of The RMSTransportMod Module
Summary of Contents for RMS 3.0
