![background image](http://html1.mh-extra.com/html/amx/rms-3-0/rms-3-0_manual_2938987025.webp)
Upgrading from MeetingManager 1.0
17
RMS NetLinx Programmer’s Guide
If you did not use the worksheet, your code probably calls MMChangeParam() to
notify MeetingManager of the Lamp Hours change. You will want to change
your code from:
MMChangeParam (dvProj,MM_PARAM_SET,Value)
To
RMSSetLampHours(dvProj,Value)
Communication Timeout
In MeetingManager 1.0, communication timeout for a source other than a
Projector or a VCR was handled by creating a named device and a parameter for
that device called "Device Communicating". This method will still work under
RMS 2.0 without changes.
However, a new report in RMS 2.0, Device Communicating Quality of Service,
requires that device communications be monitored using a support module, such
as RMSProjectorMod or RMSTransportMod. To handle devices other than
projectors and VCRs, a new support module, RMSBasicDeviceMod, was added.
RMSBasicDeviceMod monitors a device for Power, Communication Status,
Control Failure (optional), and IP Address. This module simplifies monitoring
device communications.
To use this new module, make the following changes to your programming:
Remove the registration of the named device and the "Device
Communicating" parameter.
Remove the calls to parameter access function, such as
MMSetDeviceCommunicating(), in your code, which should be
located under the DATA_EVENT for the device to be monitored.
Include a new RMSBasicDeviceMod module for the device to be
monitored.
Call RMSSetDeviceInfo() to set the name, manufacturer, and model of
the device to be monitored.
Call RMSSetCommunicationTimeout() to change the default timeout
from 300 seconds to another value unless the 30 second default is OK
for your program.
Make sure to leave a polling command that elicits a response from the device.
The RMSBasicDeviceMod will expect to receive a string from the device every
Summary of Contents for RMS 3.0
