AMX Radia RE-DM6, Operation/Reference Manual

Page: 22 / 104

Installation
16 RE-DM4 and RE-DM6 RADIA Eclipse Dimmer Modules
connection, the 12VDC supply to the processor will allow program changes if the 120VAC supply is cut
off.
Conduit
Conduit runs depend on the enclosures you use and their AMX Lighting modules. All enclosures have
conduit knockouts on the top for high-voltage connections, and knockouts on the bottom for low-voltage
connections.
All conduit knockouts allow for 1/2, 3/4, and 1-inch (12.7 mm, 19.0 mm, and 25.4 mm) conduits as
shown in FIG. 11. You should also consider these recommendations prior to installing enclosures:
Install separate conduit for lighting loads. The recommended knockout for loads is located on
the top center of the enclosure.
Install separate conduit for the 120 VAC wiring to the line input terminal block. The
recommended knockouts for incoming power feeds are located on the top-left and top-right
sides of the AMX Lighting enclosure.
Install separate conduit for low-voltage signals for dry closures and AXLink connections. The
recommended knockout for these control connections is located on the bottom of the enclosure.
Additional knockouts are on the bottom-left and bottom-right sides of the enclosures for alternate low-
voltage connections.
FIG. 11 Knockout locations (RDA-ENC2 used as example)
TOP
BOTTOM
LEFT SIDE FRONT RIGHT SIDE
B
A
C
A
C
A
E G
F
A
E
D D
Knockout
Knockout
Knockout
Knockout
Knockout
Knockout
All knockouts
are for 1/2" (1.26 cm),
3/4" (1.90 cm), and
1" (2.54 cm)
conduit
A = 3.94" (100.0 mm)
B = 6.03" (153.1 mm)
C = 3.00" (76.2 mm)
D = 1.00" (25.4 mm)
E = 9.75" (24.76 cm)
F = 6.00" (15.24 cm)
G = 11.90" (30.22 cm)
Install the control modules according to local and National Electrical Code (NEC) regulations.