3.1 Executing and Disconnecting
Switches
A switch is an active connection between a source signal and one or
more destination devices. Before executing or disconnecting a switch on
the Precis Remote, make sure the panel is in Switch mode. If you are
unsure which mode the Precis Remote is in, press the Cancel key — all
the lights on the panel turn off, and the panel reverts to Switch mode.
Follow the instructions below to execute and disconnect switches.
Note:
When executing or disconnecting switches, make sure the
Comm LED in the upper right-hand corner of the panel blinks. If it
does not, check the Comm Link connection on the back of the panel
and the connection at the switcher.
To execute or disconnect a switch:
1. Press a Level key to select a level.
The Level key illuminates.
If you do not select a level, the system executes or disconnects the
switch on the level associated with the All Level key. (The default
level for that key is video and audio.)
2. Press a Source key to select a source.
The Source key flashes, and after a moment, any destinations that
signal is already routed to illuminate. The flashing key is the “hot”
key; all other commands center around that source until you select a
different source or change the mode or level.
3. Press a Destination key(s) to select a destination(s).
Selecting (illuminating) a disconnected (unlit) Destination key
executes a switch; deselecting a connected (illuminated) Destination
key disconnects a switch.
Note:
Although our instructions direct you to select a source first, you
may execute and disconnect switches by selecting the destination first,
making that Destination key the “hot” key (see step 2 above). Only one
source signal at a time can be routed to a single destination.
3-2
Precis Remote X/Y Control Panel
Operating the Precis Remote Panel
Operating
Summary of Contents for Precis
Page 1: ......