2.2 Applying Power
Power can be applied to the Precis Remote using either of the two power
connectors, the 7 to 12 volt DC or the 5 volt DC. The AutoPatch wall
transformer can
only
be used with the 7 to 12 volt DC connector (see the
instructions below).
If using a transformer other than the AutoPatch wall transformer or a
centralized power source, the acceptable power for the Precis Remote
using the left connector is 7 to 12 volt DC with at least 500 mA.
Acceptable power for using the right connector is 5 volt DC with at least
500 mA. See the transformer or power source documentation for wiring
information.
To apply power to the Precis Remote using the AutoPatch wall
transformer:
1. Unplug the 7 to 12 V power connector from the back of the panel.
2. Connect power wires to the power connector by loosening the top
and bottom screws, inserting the wires as show in Figure 6, and
tightening the screws.
The side of the wire with the white stripe is positive, and the other
side is ground.
3. Plug the connector back into the panel (see Figure 6).
4. Plug the wall transformer into the power source.
Note:
After applying power to the panel, make sure the Power LED in
the upper right-hand corner on the front of the panel is illuminated. If it
is
not
illuminated, check the power link on the back of the panel.
Precis Remote X/Y Control Panel
2-3
Applying Power
Installing
Figure 6: Plug the wired connector back into the panel
5 V connector
Positive
Ground
7-12 V connector
Summary of Contents for Precis
Page 1: ......
