Installation & Setup
27
Precis HT Instruction Manual
Serial Control Device Startup
If you have not already done so, attach the serial control device to the CONTROL port on the enclosure
(see page 19) and open the control program.
AMX Control Devices
The Precis HT is compatible with a number of AMX control devices. For control programming
information, see the instruction manual for the specific interface.
APControl 3.0
If you are using APControl 3.0, install and open the program. Follow the directions in the setup wizard.
From the Launchbar menu, select Views / CrossBar and click on the crosspoints to execute switches.
APWeb
For startup information, see the
APWeb Server Module
documentation.
HyperTerminal
When power is applied to the enclosure, HyperTerminal displays a short splash screen (FIG. 18).
The system is ready to disconnect the factory default switch and to execute a test switch (see page 28).
FIG. 18 shows an example of a short splash screen (your system’s splash screen may differ). The short
splash screen provides the following information:
Appcode version
– enclosure’s firmware version
Neuron ID
– for internal AMX AutoPatch use
XNet ID
– enclosure’s XNNet identification number
Note:
AMX reserves the right to add to the contents of the splash screen at any time, without notice
.
FIG. 18
Power-up splash screen example
AutoPatch Precis Signal Router 8x4
Appcode version: 3.0.0
Neuron ID 00-A3-21-97-62-00
XNet ID: 00 00 26 0A
determine software version
Summary of Contents for Precis HT
