![background image](http://html1.mh-extra.com/html/amx/modero-nxd-cv5/modero-nxd-cv5_operation-reference-manual_2938958025.webp)
Installation
19
5" Modero Widescreen Touch Panel
Pre-Wall Installation of the Rough-In Box
Wall Mount panels (NXDs) are contained within an outer housing (back box). This back box is
not
removed when installing the NXD into a CB-TP5 Rough-In Box. The back box is
only
removed to gain
access for the replacement of the internal components.
The CB-TP5 is an optional metallic box that is secured onto a stud/beam in a
pre-wall
setting (
where no
walls are present
). Installation procedures and configurations can vary depending on the installation
environment. This section describes the installation procedures for the most common installation
scenario. The most important thing to remember when mounting this rough-in box is that the NXD-CV5
Mounting Tabs must lie flush against the outside of the sheetrock (FIG. 17).
Refer to
SP-2261-01
for detailed installation dimensions.
It is recommended that you cut out the surface slightly smaller than what is outlined in the
installation drawings so that you can make any necessary cutout adjustments.
The wiring knockouts on the left side will be used for the NXD-CV5 Wall Mount panel
connectors, so always secure the rough-in box to the stud using the Stud Mounting Holes on
the right side of the box.
1.
Rest the right Stud Mounting tabs onto the stud (keeping the knockouts on the left).
Be sure to
leave enough of a gap between the stud and NXD Mounting tabs to accommodate the
installation of the drywall or sheetrock after the rough-in box has been mounted. Ultimately,
the Mounting Tabs should lie flush against the outside of the sheetrock.
2.
Fasten the CB-TP5 rough-in box to the stud through the holes on the right Stud Mounting tabs
(FIG. 17), using either nails or screws.
3.
Remove the wiring knockouts from the left side of the rough-in box (CB-TP5) (FIG. 17) to
accommodate the cables being threaded through to the NXD touch panel.
FIG. 16
Installing the No-Button Bezel Kit (NXA-BEZ-5NB)
No-Button Trim Ring
Faceplate (outer surface shown)
Hollow button openings
INSTALLER: LEAVE A GAP BETWEEN THE STUD AND ROUGH-IN BOX
MOUNTING TABS TO ACCOMMODATE THE DRYWALL or SHEETROCK.
This gap allows the installation of the drywall or sheetrock after the CB-TP5 Rough-In
Box has been installed.
Summary of Contents for Modero NXD-CV5
