![background image](http://html1.mh-extra.com/html/amx/axd-el-plus/axd-el-plus_instruction-manual_2939179048.webp)
Replacing the Batteries
44
Electroluminescent LCD Touch Panels
8.
Plug the 2-pin power or AXlink connector back into the touch panel for approximately 1
minute. Then, remove connector from the panel again.
9.
Gently tilt the circuit card down towards the connector side and pull backwards until you clear
the connector housing. Then, slowly rotate the circuit card backward again until you can lay it
down flat with the batteries exposed.
10.
Carefully slide the other battery out of its socket, and insert the new battery.
11.
Rotate the circuit card back to the original position and place it in the touch panel housing.
Align the screw hole and insert the Phillips-head screw and tighten.
12.
Place the bottom panel on the touch panel and align the screw holes. Insert the seven Phillips-
head screws and tighten.
13.
Plug all connectors back into the touch panel.
AXD-EL+ (/PB), and AXM-EL+/PB Batteries
Remove the lithium batteries from the touch panel:
1.
Discharge the static electricity from your body by touching a grounded object and unscrew the
Decor-style faceplate.
2.
Using a flat-blade tool unscrew the Decor-style faceplate.
3.
Remove the four #6-32 mounting screws and carefully lean the touch panel backward to
expose the connectors.
4.
Disconnect all the connectors and remove the touch panel from the Back Box or equipment
rack.
5.
Flip the touch panel facedown onto a soft cloth and remove the four circuit card spacers.
6.
Carefully pry one battery out of its socket and insert the new battery.
7.
Return the touch panel to the Back Box or equipment rack and connect the power or AXlink
connector back into the rear side of the panel for approximately 1 minute. Then, remove the
connector from the panel again.
8.
Flip the touch panel facedown onto a soft cloth and carefully remove the other battery out of its
socket and insert the new battery.
9.
Return the touch panel to the Back Box or equipment rack and reconnect all the connectors.
10.
Insert the four rack mounting screws and tighten.
11.
Place the Decor-style faceplate onto the bezel and install the engraved overlay.