![background image](http://html1.mh-extra.com/html/amx/axd-el-plus/axd-el-plus_instruction-manual_2939179022.webp)
Designing Touch Panel Pages
18
Electroluminescent LCD Touch Panels
Creating a Bargraph and Joystick
Bargraphs are level monitors and adjustable level controls. These levels can be configured to
monitor and adjust audio outputs and lighting levels.
Joysticks are vertical and horizontal direction controllers you can use for camera for pan and tilt
control. Before you start, make sure to connect the touch panel to your Controller; otherwise, the
joystick will not work properly.
Adding a bargraph or joystick button\
Create a new button using the ADD operation bar in the BUTTON menu.
1.
Press BUTTON in the Edit bar to open the BUTTON menu.
2.
Press PROPERTIES in the BUTTON menu to open the PROPERTIES operation bar.
3.
Press any button to open the Button Properties page.
4.
Press BUTTON TYPE to open the BUTTON TYPE menus. Choose a button type to open its
Button Properties page.
Setting Bargraph and Joystick Properties
Use the Button Properties page to set channel, level, and button colors. Refer to the
Setting the
variable text code
section on page 16 and the
Setting the channel code
section on page 15 for
further information. Refer to the
Setting the button colors for channel-off conditions
section on
page 16 for more information on colors for channel-off conditions.
Setting the level code
Level buttons set the device and number codes for the touch panels.
1.
Press DEV to open a keypad and set the device number.
2.
Enter 1, 2, 3, or 4 in the keypad. The programming software uses device codes
1 - 4 to identify the touch panel.
3.
Press ENTER to save the level device number, close the keypad, and return to the Button
Properties page.
4.
Press NUM to open a keypad and set the level number assigned to the device.
5.
Enter a number 1 – 8. Each device can have from 1 – 8 levels
except
joysticks, where the range
is 1 – 7.
6.
Press ENTER to save, close the keypad, and return to the Button Properties page.
Joysticks actually use two level numbers. The first is for the X-axis and the second is
for the Y-axis. You only need to specify the first level.