![background image](http://html.mh-extra.com/html/amx/axcent3-pro/axcent3-pro_instruction-manual_2937809009.webp)
Installation
5
Axcent
3
and Axcent
3
Pro Integrated Axcess Controllers
5.
Align the bracket holes with the mounting brackets on the equipment rack. Then, start the
mounting screws on both sides of the controller and tighten.
6.
Connect the data cables into the controller. Then, secure the data cables to the CSB.
7.
Connect the power cable to the AXLINK/PWR connector to power-up the controller. Then,
secure the cable to the CSB.
Wiring the Axcent
3
Each connector you use to control external devices must be wired according to the information in
this subsection.
Preparing and connecting captive wires
1.
Strip 0.25 inch of wire insulation off all wires.
2.
Insert each wire into the appropriate opening on the connector according to the wiring
diagrams and connector types.
3.
Turn the flat-head screws clockwise to secure the wire in the connector. Do not over-torque the
screw; doing so can bend the seating pin and damage the connector.
FIG. 3
CSB mounting diagram
CSB Cable Support Bracket
Mounting
screws
2"
4"
6"
Mounting
screws
2", 4", 6" Mounting Configurations
Summary of Contents for Axcent3 pro
Page 4: ...ii Axcent3 and Axcent3 Pro Integrated Axcess Controllers Table of Contents ...
Page 27: ...Axcess Programming 23 Axcent3 and Axcent3 Pro Integrated Axcess Controllers ...
Page 28: ...Axcess Programming 24 Axcent3 and Axcent3 Pro Integrated Axcess Controllers ...
Page 33: ...Updating Firmware 29 Axcent3 and Axcent3 Pro Integrated Axcess Controllers ...