![background image](http://html.mh-extra.com/html/amx/axcent3-pro/axcent3-pro_instruction-manual_2937809011.webp)
Installation
7
Axcent
3
and Axcent
3
Pro Integrated Axcess Controllers
GND wire on the AXlink/PWR connector when using a separate 12 VDC power supply. Do not
connect the PWR wire to the AXlink connector’s PWR (+) opening.
Relay connections
Connect up to eight independent external relay devices to the 16-pin RELAYS connector. Use A for
common and B for output. Each relay is isolated and normally open. A metal connector strip is also
provided to common multiple relays.
IR/SERIAL/DATA connections
Connect up to six IR, IR/Serial, and/or DATA (transmit only, 0 - 5 VDC levels only) devices to the
12-pin IR/SERIAL/DATA connector shown in FIG. 8. You can connect a CC-IRC Infrared Emitter,
external serial device with a 2-pin captive-wire. You can also connect a data 0 - 5 VDC device.
Input/Output connections
Connect up to six Input/Output (I/O) devices to the INPUT/OUTPUT 8-pin connector, as shown in
INPUT/OUTPUT 8-pin (male) connector
section on page 7. A contact closure between GND and
an I/O port is detected as a PUSH. When used for a voltage input, the I/O port detects a low (0 - 1.5
VDC) as a PUSH, and a high signal (3.5 - 5 VDC) as a RELEASE. When used for an output, each
I/O port acts as a switch to GND and is rated at 200 mA @ 12 VDC.
+12V
- 12 VDC power output for PCS Power Current Sensors, VSS2 Video Sync
Sensors, or similar I/O-type equipment
I/O 1 - 6
- Six I/O ports
GND
- Common ground shared with I/O ports 1 - 6
FIG. 7
RELAY 16-pin connector
FIG. 8
IR/SERIAL/DATA 12-pin connector
FIG. 9
INPUT/OUTPUT 8-pin (male) connector
6
A
B
8
A
7
B
B
RELAYS
B
A
B
5
A
4
A
A
B
3
A
2
B
B
1
A
6
IR / SERIAL / DATA
5
4
3
2
1
I
/ O
5
INPUT / OUTPUT
12
V
I
/ O
6
I
/ O
4
I
/ O
3
I
/ O
2
GND
I
/ O
1
Summary of Contents for Axcent3 pro
Page 4: ...ii Axcent3 and Axcent3 Pro Integrated Axcess Controllers Table of Contents ...
Page 27: ...Axcess Programming 23 Axcent3 and Axcent3 Pro Integrated Axcess Controllers ...
Page 28: ...Axcess Programming 24 Axcent3 and Axcent3 Pro Integrated Axcess Controllers ...
Page 33: ...Updating Firmware 29 Axcent3 and Axcent3 Pro Integrated Axcess Controllers ...