![background image](http://html.mh-extra.com/html/amx/axcent3-pro/axcent3-pro_instruction-manual_2937809012.webp)
Installation
8
Axcent
3
and Axcent
3
Pro Integrated Axcess Controllers
Program connector (front and rear panels)
Connect a programming cable to the PROGRAM connector on the controller. The table below
shows the DB-9 connector pins and signals for the PROGRAM connector. Use the PROGRAM
connector to download Axcess programs, and to set up control communication options using the
OpenAxcess software program.
Axcess card slot connector (Axcent
3
PRO only)
FIG. 10 shows the 16-pin (male) connector that provides connection to the Axcess Control Cards.
After installing control cards, refer to the literature provided with the control card for wiring and
Axcess programming information.
Program Connector and Pinouts
Pin
Signal
2
RXD
3
TXD
4
+12 VDC
5
GND
7
+12 VDC
Pin 1
Pin 9
PROGRAM pins 1, 6, 8, and 9 are not used. Pins 4, 5, and 7 are for an ALF
Programming Unit.
FIG. 10
Axcess Control Card 16-pin connector
SLOT 4
Summary of Contents for Axcent3 pro
Page 4: ...ii Axcent3 and Axcent3 Pro Integrated Axcess Controllers Table of Contents ...
Page 27: ...Axcess Programming 23 Axcent3 and Axcent3 Pro Integrated Axcess Controllers ...
Page 28: ...Axcess Programming 24 Axcent3 and Axcent3 Pro Integrated Axcess Controllers ...
Page 33: ...Updating Firmware 29 Axcent3 and Axcent3 Pro Integrated Axcess Controllers ...