Introduction
2
CP-10 Instruction Manual
Control Keys
Note: The following keys are not currently implemented: Special, Undo, Comma, Period, and
Up and Down Arrows.
Keys & Functions
Cancel Key –
cancels an incomplete command and returns the panel to the Command screen.
Cannot undo a completed operation, i.e., an operation followed by the pressing of the
Take Key
Take Key –
functions like the “Enter” key on a computer key board. Pressing the Take Key
instructs the system to complete an operation
Status Key –
queries the system for signal routing information and switch verification
Level Key –
prepares the system to receive a level identification number. When controlling a
system with a CP-10, the terms “Level” and “VM (Virtual Matrix)” are interchangeable
Change Key –
prepares the system to accept a Change command
Input (source) Key –
prepares the system to receive an input (source) identification number
as the next entry
Output (destination) Key –
prepares the system to receive an output (destination)
identification number as the next entry
Arrow Keys –
scroll left or right through long lists of outputs (required only when an arrow
graphic is displayed on the LCD Command screen)
Preset Key –
implements local and global presets
Program Key
–
displays software version only
Backlight Key
– illuminates the LCD for approximately 20 seconds. Press the Backlight Key
again to turn the backlight off before the 20 seconds are over
Space Key
– inserts a space between multiple outputs or multiple local presets when entering
a command. Output and local preset prompts are the only prompts that accept multiple
number entries
Number Keys (0 - 9) –
enter level, input, output, and preset numbers, and to enter digits for
any other functions that may require numbers
FIG. 2
CP-10 LCD & control panel keys
Arrow Keys
Number Keys (0 through 9)
LCD Command Screen
Command Keys
Take Key
