![background image](http://html1.mh-extra.com/html/amx/ald-1000d/ald-1000d_instruction-manual_2938273028.webp)
Programming
21
ALD-D48 Network Lighting Solutions
Command Control (Cont.)
P:K:<id>:<state>:[1:<addr>]:
<level>:<fade>
Scene programming request.
This command is used to add or remove a light from a scene.
Program mode must be enabled for this command to work
(PROG=OPEN).
<id>:
1..100 = scene id to program
<state>:
0 = remove light from scene
1 = add light to scene
? = query for all lights in a scene
1:
this value is always 1
<addr>:
1..48=address of light to add/remove
<level>:
Level of light added to scene. Only valid when
state=1. Range is 0-100 percent.
<fade>:
Fade time of light added to scene. Only valid when
state=1. Range is 0-14400 seconds.
P:K:1:?
P:K:6:1:1:26]:80:3
P:K:18:0:[1:12]
FBMODE=<mode>
Set desired feedback mode. By default, the ALD-D48 will only
report feedback using channels. This command can be used to
alter this behavior.
<mode>:
sum of the following desired feedback modes:
0 = no feedback
1 = channel feedback
2 = level feedback
4 = string feedback
FBMODE=7 // channel, level and
string feedback
FBMODE=3 // channel and level
feedback, no string
FBMODE?
Query for the current feedback mode.
FBMODE?
CONFIG?
ALD-D48 device server configuration request.
Get the current configuration information for an ALD-D48
device server.
CONFIG?
RESET
Reset request.
Forces an ALD-D48 device server to reset (reboot).
RESET
VERSION?
Version query.
Query for the current version number of the ALD-D48 device
server firmware.
VERSION?
Summary of Contents for ALD-1000D
