AMX ALD-1000D, Instruction Manual, Page: 20 / 35

Wiring ALD Switches and Dimmers
13
ALD-D48 Network Lighting Solutions
Mounting
1.
Push wires into wallbox, allowing room for control backbox to be inserted. Do not pinch wires
between wallbox and control.
2.
Mount control to wallbox using screws provided. Controls must be mounted vertically. See
stamp on control for correct positioning.
3.
Separate faceplate from faceplate adapter by holding assembly in one hand while unsnapping
the faceplate from the top.
4.
Mount control with mounting screws provided.
5.
Screw on faceplate adapter.
Component Assembly
1.
ALD-600D and ALD-1000D only: hold the ALD mini-slide with the two feet facing right and
the notched arm facing left. Fit the feet in the groove in the right side of the adapter plate and
fit the arm into the notched slider in the control. Slide it up and down to make sure the fit is
correct.
2.
To mount the button, hold it so the name "LUTRON" is right side up. Fit the feet in the groove
in the left side of the faceplate adapter. Push the two legs on right side of button gently into slot
in control. Button should fit loosely but not fall out. Snap faceplate on to the faceplate adapter.
FIG. 14 ALD Component Assembly
(