AMX ALD-1000D, Instruction Manual, Page: 21 / 35

Wiring ALD Switches and Dimmers
14
ALD-D48 Network Lighting Solutions
Operation
Dimmers
Push button in center of control to turn lights on to preset level (set by slider) and to turn lights off.
Raise slider to increase light intensity. Lower slider to decrease light intensity.
Electronic Tapswitches
Push button in center of control to turn lights on and off.
Electronic Tapswitches with Status Light
Push button in center of control to turn lights on and off. The status light will be lit when the circuit
is on. The status light will turn off when the circuit is off. can also be accomplished by moving
slider forward and backward on remote control.
For routing lamp replacement, power may be conveniently removed from fixtures by pulling clear
FASS™ (Front-Accessible Service Switch) so OFF is visible. For any other procedure other than
routine lamp replacement, power must be disconnected at main electrical panel. FASS switch must
be returned to the up (ON) position in order to operate lights (see FIG. 15).
Operation
Quickly pushing the tapswitch twice for the dimmers or the VETS-R controls connected to it will
adjust the lights to full; pressing and holding the Tapswitch 1/2 second activates a 10 second
fade-to-off.
To remove all fade action from the dimmer, turn the dimmer off. Pull the FASS down while
depressing the tapswitch. Push the FASS up and hold the tapswitch for about 10 seconds until the
light turns on. The fade is now disabled. To restore the fade action, repeat the same procedure.
FIG. 15 FASS Switch Location
System ON System OFF