Configuring The ALD-D48 Device Server
9
ALD-D48 Network Lighting Solutions
When specifying the address of the NetLinx master to which the ALD-D48 should connect there
are several options. The master can be automatically located. If this option is selected the first
master that is found on the network will be used. If the IP address of the master is known that can
also be specified. In this mode the ALD-D48 will look only for that master and, once detected, will
connect to it. Alternately, the system number of the master can be used to make the connection.
With this selection the ALD-D48 will look only for a master with the specified system number.
After you have made all the necessary configuration changes you must select
Save changes and
exit
. This will write the changes into non-volatile memory and reboot. The system will boot with
the new changes. Rebooting can take anywhere from 5 to 30 seconds. Simply exiting will result in
the loss of all changes.
FIG. 9
Specifying the NetLinx Master
Use first master that is found (y,n)? N
Specify IP address of master (y,n)? Y
Enter NetLinx master IP address: (000) .(000) .(000) .(000)
Summary of Contents for ALD-1000D
