PAGE 9
LS4600 | 6 CHANNEL SPEAKER LINE SURVEILLANCE
4.0 Auto Test
4.0 AUTO TEST
O<>
4.1 SELECT TIMER
O<> Test Seq=off
>
ENTER
# Use < or >
to select Auto or Manual mode
>
Press NEXT to Menu 5.0
PRE to Menu 3.0
>
4.2 AT.TEST ON?
O<> Y?/N?
>
ENTER
LS4600 VX.XX[SPEAKER LINE SURVEILLANCE]
<<Auto Test xxh:xxm:xxs<<-Remaining..<xxx
>
This menu must be accessed for first time programming, in which shall determine how the unit shall run, either
manually or automatically.
If SELECT TIMER mode is selected, testing interval time should be entered, otherwise, the default timer is set to off.
Once timer has been entered and auto mode selected, the unit shall immediately start testing sequence and the
counter began from then onwards.
To access to the main menu again, press Menu key
>
Return to Submenu 4.0
If Off is selected
If a test interval is selected (from 1 min to 24 hours). By
default, auto mode is set to off. Use < or > key to select time.
ENTER
>
>
If NO is selected
Return to Submenu 4.0
Press < or > to select ON or OFF for Auto
Test.
If Auto Test is ON
Menu
The test sequence is started and
repeated at the preset interval.
Remainning time for the next
sequence is displayed.
5.0 Buzzer
5.0 BUZZER
o<>
5.1 KEY BEEP
ENTER
>
Press NEXT to Menu 6.0
PRE to Menu 4.0
>
5.2 FAULT BUZZER
>
Buzzer is available for button pressing and alert / fault signal. This feature can be turned off to fit to ones' preference.
For fault alert buzzer, if this is switch on, the Buzzer LED shall not lit when a failure is detected. If the buzzer is switched off,
the buzzer LED and the correspondence channel fault LED shall lit.
>
ENTER
>
Press < or > to select ON / OFF
whenever fault is detected.
Return to Buzzer Menu
Press < or > to select ON / OFF for
key select.
