PAGE 6
LS4600 | 6 CHANNEL SPEAKER LINE SURVEILLANCE
1.0 Setup Menu
Press ENTER and PRE or NEXT key for setting up remaining channels or MENU to return to previous menu.
BP = Bypass
1.1 CH.No.#
Accept?/Bypass?
1.1 CH.No.#
Bypass ?
1.1 CH.No.#
Accept ?
1.1 CH.No.#
Bypass OK
1.1 CH.No.# *
o<> Imp xxxx
1.1 CH.No.#
Accept OK
1.2 BP ON FAULT
o<> <ON> CH.#
1.2 BP ON FAULT
o<> <OFF> CH.#
ENTER
>
>
ENTER
>
>
NEXT
>
NEXT
>
PRE
>
PRE
>
* Default <ON>
>
ENTER
>
>
Channel bypass mark *
BASIC SETUP
Use PRE or NEXT keys to select the required channel. Imp value shall be shown, otherwise OPEN or SHORT shall
appear. Press ENTER to proceed to the next setting for the selected channel. A channel with or without value can be
bypassed from surveillance or accepted for monitoring. Select PRE to accept for monitoring or NEXT to bypass.
In BASIC Mode Hi and Lo function will be disabled, only OPEN and SHORT monitoring available.
To enable Hi and Lo function use ADVANCE setup in menu 1.0 (SETUP)
The ' * ' symbol will show when the value measured is out of preset range of Hi and Lo limits.
Short or Open condition is self explainatory.
A fault condition shall have red LED lit and vice versa.
NEXT to Menu 2.0
>
1.0 SETUP
o<>
PRE to Menu 7.0
>
ENTER
>
1.0 BASIC SETUP
o<>
ENTER
>
1.1 CH.No.#
o<> Imp xxxx
ENTER
>
Use < or > to toggle between Basic and
Advance Setup
Press < or > to switch channel number.
Press < or > to accept the value
of status.
MENU
Back to Menu 1.0
>
There are 2 modes of operation available : Basic and Advance.
In Basic setup mode, LS4600 shall detect the circuit for Open and Short only. The timing of detection shall depend on the
intervals set in Auto Detection mode, ( Refer to Auto Test section ). Follow the steps below to use this mode.
