38
b)
Once the power light begins blinking, the camera will begin to broadcast a Wi-Fi network with the name
“APOLLO_XXXX” at this point you will have several minutes to log onto the camera’s Wi-Fi network to
complete your setup. You will need to go to your mobile device’s Wi-Fi settings, connect to the Wi-Fi
network “APOLLO_XXXX” then return to the APOLLO app and continue the setup process.
c)
If you still do not see the camera’s setup Wi-Fi network, reset the camera to default settings and try
again. To reset the camera, check that the camera is powered on, use a paper clip and press and hold
the Reset button on the back of the camera for 10 seconds. The power light should begin to blink and
the camera will reboot. Once the light becomes solid, go through the setup process on the APOLLO app
again.
The APOLLO app cannot connect to the camera during setup. I get an error that says the “Setup Wizard cannot
communicate with your Camera.”
a)
You may not have connected your mobile device to the camera’s Wi-Fi network. Your mobile device
must be connected to the camera’s Wi-Fi network to communicate with it during the setup process.
b)
Press the Setup button on the back of the camera and hold it for 3-5 seconds until the front power light
begins to blink.
c)
Once the power light begins blinking, the camera will begin to broadcast a Wi-Fi network with the name
“APOLLO_XXXX” at this point you will have several minutes to log onto the camera’s Wi-Fi network to
complete your setup. You will need to go to your mobile device’s Wi-Fi settings, connect to the Wi-Fi
