amiad Filtomat MG-110P, Installation, Operation And Maintenance Instructions

Page: 31 / 51

MG110P
7.2013 Page 31 of 51
Number Screen Description
4
TimeBet.Flushing
5:00:00 (D:H:M)
This screen defines the time between scheduled flushing cycles. The
entry format is Days (0-99), Hours (0-23) and minutes (0-59).
5
FlushTime: 00:20
Bet.Filt.: 00:10
Upper line:
Defines the flushing time (the duration of flushing) of one filter. The
entry format is Minutes (0-99) and Seconds (0-59).
Lower line:
Defines the delay time between filters (between the end of one filter
flushing and the beginning of the next). The entry format is Minutes (0-
XX) and Seconds (0-59).
6
Flu Til Fault: 3
Delay: 10
Upper line:
Defines the number of maximum flushing cycles till fault; the maximum
allowed number of continuous flushing cycles when the DP signal
remains continually ON (probably due to a filter clog). If this number is
exceeded the controller enters into Fault mode and activates the alarm.
The entry format is 0-9.
Lower line:
Defines the delay between one flushing cycle and the next when the
controller receives a continuous signal from the DP switch. The entry
format is Seconds (0-99)
7
Delay: D.P.: 19
Defines the time required for the DP signal to remain ON until the
controller responds by activating the flushing cycle. The entry format is
Seconds (0-99).
8
Delay main valve
Close: 1 Open: 0
Note: This screen appears only if a main valve is configured and it defines
the main operation as described in chapter B.
Close: The time between closing the main valve and activating the
flushing cycle.
Open: The time between deactivating the flushing cycle and opening
the main valve.
The entry format is Seconds (0-99).
9
Delay valve
Open: 5 close: 5
Note: This screen appears only if a Delay valve is configured and it
defines the Delay valve operation as described in Annex A.
The entry format is Seconds (0-99).