Page 7
Floor
43” to 44”
Wall Mounting Instructions
Choosing the Location
It is recommended that the jukebox be mounted to a
wall with the bottom approximately 35” to 36” up from
the floor. The wall must be strong and flat. The
jukebox should be visible and convenient to use. Do
NOT install directly above a radiator or other source
of heat. Be sure the speaker wires can be easily run
to the unit.
WARNING
The mounting of the jukebox on the wall
should be done by a qualified installer
familiar with wall construction and loading.
The wall and installation hardware MUST be
capable of supporting a 170 lb. load.
Failure to follow these instructions could
result in serious injury.
For easier installation, the Rock-Star Lx is shipped
with the front door detached from the cabinet. After
mounting the cabinet, the front door is easily attached
to the cabinet.
Tools and hardware required for normal installation
into wood wall studs:
•
Socket wrench with 7/16” and 3/4” sockets.
•
Level
•
Pencil
•
Punch or Awl (to start the lag screws)
•
(4) 1/4” x 1-1/2” Lag screws provided
•
Masking Tape
1. Remove the mounting bracket locking bolt from
inside the jukebox (
Figure 3-B
) to release the
mounting bracket from the back of the jukebox.
Figure 3-B – Inside View of the Top of Cabinet
2. Mount the bracket to the wall with the lower
edge 43” to 44” up from the floor using 1/4” x
1-1/2” lag screws that attach to wooden wall
studs as shown in
Figure 4-B
. Be sure the
bracket is level.
Figure 4-B – Mounting Bracket on Wall
NOTE:
If the wall is concrete, cinder block, brick, or
uses metal wall studs, then the appropriate fasteners
must be used. At least 4” heavy duty fasteners (one
in each corner) must be employed. The fasteners
must be able to support a 170 lb. object. Do NOT
use “press-in” anchors or any other “light” or
“medium” duty fasteners. Consult a contractor
experienced in the type of construction used if there
is any doubt about the strength of the mounting
devices.
3. Prepare the wiring. The power cord should be
attached to the back of the jukebox near the
bottom before mounting. The speaker and other
wiring enter the back of the jukebox near the top
of the hinge side
(see Figure 3-B).
4. Place masking tape on the wall where the sides
of the jukebox will be when the unit is hung from
the bracket. The outside of the jukebox is 3-
1/16” from the edges of the wall bracket. (See
Figure 5-B
).
Figure 5-B – Mounting Bracket
Wire Access Holes
Bracket Locking Bolt
3-1/16”
Summary of Contents for Rock-Star Lx
