Released 06/2010
E-mail: [email protected]; [email protected]; website: www.amfreece.com
Phone: +420 582 309 286; Fax: +420 582 360 606
DECO 2000
1-47
1 2. A D J U S T M E N T A N D T I M I N G O F B E N D E R P L AT E
1) Raised position of bender plate
1.1.
Loosen two screws to remove the metal table - holder of the throat plates.
1.2.
Release the angle plate latch for pick stitch operation. Rotate the handwheel to bring the bender
plate fully up.
1.3.
Loosen the screw attaching the pusher plate.
1.4.
Lift the presser foot away from the bender plate. Move the bender plate for 0,4 mm clearance from
the needle. Tighten the screw.
2) Adjust bender plate height
2.1.
Bring the bender plate into the down position.
2.2.
Loosen the jam nut on the bracket rod. Turn the adjusting bushing to align the end of the bender
plate towards the operator flush with the throat plate. This should set the opposite end of the bender
plate at 0,4 mm above the throat plate. Tighten the jam nut.
3) Align to the throat plate
3.1.
Loosen the clamping screw and also loosen two screws holding the pivot support.
3.2.
Align the edge of the notch for the feed dog on the bender plate with the edge of the feed dog slot
on the throat plate.
3.3.
Tighten the pivot support screws. Adjust the pins to the bender plate and tighten the clamping screw.
4) Timing the plate
4.1.
Release the angle plate latch for pick stitch operation.
4.2.
Rotate the handwheel to move the needle into the lower needle bar.
4.3.
Rotate to bring the presser foot down to the throat plate. Stop when the presser foot is 0,4 mm
above the throat plate.
4.4.
Loosen two screws holding the angle plate cam on the main cam shaft.
4.5.
Rotate the cam to just start the bender upward. Tighten the cam.
E - STANDARD MACHINE ADJUSTMENT