Ametek Land LSP-HD Series, Installation Manual

Page: 11 / 40

Page 5
Installation Guide LSP-HD Mountings & Accessories
2.1.2 Binder Connector disassembly
1) Unscrew the threaded clamp ring
which holds the cable and terminal
block in the main body of the
connector.
2) Unscrew the inner metal clamp ring
and slide the plastic clamp and inner
rubber washer along the cable.
Remove the lid of the connector
shell. Make sure that you retain the
thin rubber seal for refi tting.
2) The four wires in the end terminal block are in two twisted pairs: A Black/
White pair and a Black/Red pair.
Unscrew the terminals to disconnect the wires, making sure that you retain
them in the correct twisted pair.
3) Remove the connector shell, clamp rings, washers etc. from the cable and
pass the free end of the cable through the cable gland on your mounting
accessory.
4)
White/Black twisted pair
Red/Black twisted pair
View on front of connector
Correct orientation
of notch
1
2
3
4
Re-connect the wires to the terminal
block according to the cable schedule
below:
Terminal Nº Colour
1 Black
1
2 White
1
3 Black
2
4 Red
2
1 - Twisted pair 1
2 - Twisted pair 2