Ametek Land LSP-HD Series, Installation Manual

Page: 9 / 40

Page 3
Installation Guide LSP-HD Mountings & Accessories
The LSP-HD I/O Processors comprise a choice of:
•
LSP-HD I/O Processor 1 (Land Part Nº 805773) – 4 digital in, 4 digital out,
2 analogue in, 4 analogue out
• LSP-HD I/O Processor 2 (Land Part Nº 805774) - 8 digital in, 12 digital out,
4 analogue in, 12 analogue out
• LSP-HD I/O Processor 3 (Land Part Nº 805775) – Customisable I/O
• LSP-HD I/O Processor for Single Floatline Measurement (Land Part Nº
805778)
• LSP-HD I/O Processor for Four Floatline Measurement (Land Part Nº
805779)
• Power Supply Unit for LSP-HD I/O Processor (Land Part Nº 805953)
The LSP-HD software accessories comprise a choice of:
• Landscan Processor Configuration Software (from version 3.51)
• Landscan WCA Software (from version 5.7)
2.1 LSP-HD Cable assembly
Note
When mounting an LSP-HD scanner in either the Floatline Housing, Light
Steel Mounting or Heavy Steel Mounting, you must disassemble and
remove the L-shaped connector from the LSP-HD cable, thread the cable
through the cable gland on the mounting and re-assemble the connector.
There are two types of connector used with LSP-HD:
• Phoenix Connector (See Section 2.1.1)
• Binder Connector (See Section 2.1.2)
2.1.1 Phoenix Connector disassembly
1) Unscrew the bezel that grips the outer sheath of
the cable.
2) Slide the bezel back along the length of the ca-
ble a little.