AMERITECH AM8a, Instruction Manual

Page: 32 / 152

AM8a Instruction Manual (18-0037) Front Panel Operation
0037-S01.L_19 February 10, 2000
1-15
1.9 STORE SETUP
The
STORE
function will save up to 20 different Configuration setups and up to 20 different
Emulate/Analyze parameter sets. To store parameters in either
SETUP
category, press [
SHIFT
]
then [
STORE
], followed by the appropriate number as indicated in the following sequence:
NOTE:
The
STORE
function will NOT operate while the AM8a is set to the
EVENTS
Display or is displaying the
DATE/TIME
. Current parameters for
EMULATE/ANALYZE
will be stored if their locations are specified, even if the
CONFIG'N SETUP
mode is selected (and vice verse).
1. Press [
SHIFT
] (so its green LED is on) then [
STORE
][n][n].
nn = 00 - 19 for CONFIG
20 - 39 for EMULATE/ANALYZE
2. After the storage location has been input, one of the following displays will
appear with instructions for the next actions.
STORE TRUNK CONFIGURATION ?
PRESS "MENU UP" (YES), OTHER KEYS (NO)
Pressing Menu up will store the current
Config setup, any other key will abort
the store sequence.
STORE EMULATE/ANALYZE ?
PRESS "MENU UP" (YES), OTHER KEYS (NO)
Pressing Menu up will store the current
Emulate/Analysis setup, any other key
will abort the store sequence.
;; CAN NOT STORE, SETUP PROTECTED
PRESS ANY KEY TO CONTINUE
This display will appear if the setup is
protected. If storage is still desired, go
to the Config Setup menu and disable
the memory protect. Then repeat the
Store sequence. Be sure to enable the
memory protect upon completion of the
storage.
NOTE:
Some Configuration parameters are not are included in a stored
Configuration. They are: Protect/Unprotect, Baud Rate, Parity,
Date/Time, Password, and Display Mode. Since they are not stored, they
also cannot be recalled; values that appear on power up are whatever were
last set.