RECOMMENDED TOOLS AND MATERIALS
Putty Knife
Regular Screwdriver
Adjustable Wrench
Sealant
Tape Measure
Hacksaw
Wax Ring/Gasket
Flexible Supply Tube
Closet Bolts
Carpenters Level
1
REMOVE OLD TOILET
a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b. Disconnect and remove supply line. NOTE:
If replacing valve, first shut off main water supply!
c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE:
Mounting surface must be clean and level
before
new toilet is installed!
S
A
VE FOR FUTURE USE
3
2
CLOSET FLANGE
CLOSET BOLTS
7 3 0 2 010 - 10 0 Rev. A
A
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a , I n c .
© A S A m e r i c a , I n c . 2 0 1 3
NOTE:
Pictures may not exactly define contour of china and components.
ROUGHING-IN DIMENSIONS:
NOTE:
Distance from wall to closet flange centerline must be as listed below:
5
4
INSTALL WAX SEAL
Invert toilet on floor (cushion to prevent damage), and
install wax ring evenly around waste flange (horn), with
tapered end of ring facing toilet. Apply a thin bead of
sealant around toilet base.
POSITION TOILET ON FLANGE
a. Unplug floor waste opening and install toilet on closet flange so bolts project
through mounting holes.
b. Loosely install retainer washers and nuts. Side of washers marked "THIS
SIDE UP"
must
face up!
WAX RING
SEALANT
WASHER
NUT
FLANGE
BOLT
T
HIS
SIDE UP
Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly,
please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your
installation conforms to local codes.
!
INSTALL CLOSET BOLTS
Install closet bolts in flange channel, turn 90°, and slide
into place 6" (152 mm) apart and parallel to wall.
LOFT
®
1.28 GPF ONE-PIECE TOILET
Model 2535 – Compact Elongated Right Height™ with Seat
INSTALLATION INSTRUCTIONS
SUPPLY
AS
REQ'D
*10"
(254mm)
FINISHED WALL
FINISHED
FLOOR
C/L OF SEAT POST HOLES
140mm (5-1/2" CENTERS)
28-7/16"
(723 mm)
14"
(355 mm)
14"
(356 mm)
9-5/16"
(236 mm)
10-3/16"
(259 mm)
12"
(305 mm)
11-15/16"
(303 mm)
18-1/2"
(470 mm)
7-3/16"
(183 mm)
3/4"
(20 mm)
3"
(77 mm)
11/16"
(18 mm)
16-1/2"
(419 mm)
28-5/8"
(727 mm)
14-7/16"
(366 mm)
