American-Lincoln
29
SC7750 IC
WARNING
Do not turn the steering wheel sharply when the machine is in motion. The machine is very responsive to
movement of the steering wheel. Do not make sudden turns. Scrub in straight paths. Do not bump posts. Do
not scrape the sides of the machine.
When the machine is in motion, do not push the directional/speed control pedal all the way forward. This is the
same as starting in “High” and will put a strain on the motor and drive system.
1.
Plan your sweeping and scrubbing in advance. Try to arrange long runs with minimum stopping and start
ing. Sweep debris from narrow aisles out into main aisles ahead of time. Do an entire floor or section at
one time.
2.
Pick up oversize debris before sweeping.
3.
Allow a few inches of overlap of sweep and scrub paths. This will eliminate leaving dirty patches.
4.
Do not turn steering wheel too sharply when the machine is in motion. The machine is very responsive to
movement of the steering wheel, so avoid sudden turns.
5.
Try to follow as straight a path as possible. Avoid bumping into posts or scraping the sides of the machine.
6.
When placing the machine in motion, avoid slamming the directional control pedal all the way forward
quickly. This is equivalent to starting in “High” and puts needless strain on the engine and drive system.
7.
Always allow the machine to warm up before operating in cold temperatures.
8.
Periodically turn the sweeping broom end-over-end to prevent the bristles from “setting” in one direction.
NOTE
Replace the sweeping broom when the bristles are worn to 3 inch (8cm) length. Replace disc brushes when
bristles are reduced to ½ inch (1.3 cm) in length. Replace squeegee rubbers when all usable edges have become
rounded with wear, impairing the wiping action.
HELPFUL HINTS FOR CLEANING OPERATION
P4134/0001
SIDE AISLES
MAIN AISLE
SIDE AISLES
P4134
FIGURE 35
