14
INSTALLATION AND SERVICE GUIDE
SpeedDome Ultra III Camera Dome
8000-2573-01, REV. B
7. Connect housing and eyeball assembly to
base (Figure 14).
a. Align recessed dimple on cap of dome with
red dot in base.
b. Mate housing and eyeball assembly to base
and turn it clockwise until you hear a click.
Figure 14. Connecting housing and eyeball
assembly to base (cables and lanyard not
shown)
LATCH
8. Wait 10 seconds for dome to begin its
homing routine.
Homing routine indicates that address was
placed into dome memory and that dome is
ready for programming.
Connecting to a Base
with I/O Board
This procedure explains how to connect the
housing and eyeball assembly to a base with I/O
board. Perform the following steps on the ground.
1. Detach and discard cable clamp if I/O board
has one, and ensure termination jumper
JW1 is set correctly (Figure 15).
a. Detach I/O board from base to access
cable clamp and jumper JW1.
b. Detach and remove clamp. If not removed,
clamp can damage 9-pin connector in
housing and eyeball assembly when you
attempt to connect it to base.
c. Jumper is pre-installed across pins 1–2
(unterminated). If dome is to be connected
at the end of a communications line, place
jumper across pins 2–3 (terminated).
d. Reattach I/O board.
Figure 15. I/O board cable clamp
1
I/O BOARD
Dimple
Remove clamp if
board has one.
JW1
