22
INSTALLATION AND SERVICE GUIDE
SpeedDome Ultra III Camera Dome
8000-2573-01, REV. B
Procedure
1. Match symptom to one of the following
criteria:
−
Dome functions but does not pan
−
Dome functions but does not tilt
−
Dome does not “home” or respond to
commands even when attached to another
dome’s base and its address switches are
set correctly (dead dome).
2. Choose a, b, or c to determine if problem is
a cable connection or major component.
a. Dome functions but does not pan.
On CPU board, is pan motor ribbon cable
attached to connector P4 and is metal side
of its fingers towards contacts of
connector?
YES
Replace CPU board. If this doesn’t
work, replace pan motor.
NO
Connect cable(s).
b. Dome functions but does not tilt.
On camera/lens board, is tilt motor cable
attached to connector J3? Is slip ring cable
attached to connector J2?
YES
Replace camera/lens board. If this
doesn’t work, replace tilt motor.
NO
Connect cable(s).
c. Dome does not “home” or respond to
commands (dead dome).
On CPU board, is power supply cable
attached to connector P3? Is slip ring cable
attached to connector P2?
YES
Replace CPU board. if this doesn’t
work, replace power supply board.
NO
Connect cable(s).
Disassembling the Dome
This section explains how to remove the following
parts from the camera dome.
•
CPU board, page 23
•
Power supply, page 23
•
Pan motor, page 24
•
Slot covers, page 24
•
Camera, page 25
•
Eyeball, page 25
•
Camera/Lens board, page 26
•
Tilt motor, page 27.
CAUTION
: Once disassembled, parts of dome
housing and eyeball assembly are “extremely
fragile” and may break. Proceed using extreme
care!
This section also explains how to update and
reprogram dome software (Page 28).
To order parts, see page 28.
Tools required
•
Phillips-head
screwdriver.
•
Small slotted screwdriver.
